Public registration is permanently closed. It is sometimes open on Sundays.
Here is what I see at those airports:
The red X are located at each of the runway.
Also I can not see any winsocks.
So are those red X the winsocks?
The other Cyprus airports show red X also on my setup (4.3)
If they are the winsocks, why are they not showing the proper object?
This is not from my scenery, can`t help. never seen before.
It can be that Sode not working by you correctly. At this place are the Windsocks.
Please install Sodefiles new.
No others have this error.
SODE or the sim generally search the titel from simobjects not the model
WHEN WİLL ERCAN AIRPORT NEW TERMINAL BUILDING HAS BEEN COMPLETED?The construction has been suspended for unknown period of time as the building company has run out of money because of the turkish Lira degradation.....
So nobody knows when it will be continued!!
GoGo
The LCPH installation and small FPS.
Could anybody to describe how to copy SODE files. I have read the manual but there only copy files from SODE folder to SODE folder at your PC. In archive of SODE there are few folders with files. What files should copy to folders. For example SODE/SimObject/LCPH/Three folders of windsock/ all of three folders should be copied or only one? And what should do with cfg. file need a copy whole file or just correct existing in SODE folder?
Philipp
Copy the complete folder "SODE" from the archive to
C:\ProgramData\12bPilot
There is no cfg file inside.
Hi All
Something wrong with LCPH Addon Scenery on my PC. I have strong freezes at this scenary, after loading at the beginning I have stable 47FPS, if start looking around using ezdoc it immediately drops to 21 then up to hire rate then drop again down and all way during take off the same freezes. What can drop so strong my FPS. In other Addons like LGAV I have stable 40FTS, not lower. Pls. help.
Regards
Philipp
I have not Ezdoc, but in LCPH is nothing wrong. But think, if you have Larnacar and Ercan installed, the sim will load all Airports at the same time.
The scenery is tested with all airports in use. There are no problems.
No, I have only LCPH installed, I deleted LCEN as it had the same problem with freezes and FPS.
So, You have no idea what is wrong?
No, i don`t know your installation and hardware. Both sceneries working correct and frame friendly. I use multimonitor without drops, others also.
Dear All!
I have marked that during takeoff on the runway at LCPH the aircraft jumping like it runs on the ground with a hills not like on flat asphalt runway.
Did somebody have the same bug or known how to fix this in P3D v4?
No, i don`t know your installation and hardware. Both sceneries working correct and frame friendly. I use multimonitor without drops, others also.
Hello.
It seems like the RWs confused the texture/base under the Runway is like simple ground with humpy relief, taxiway along the RW is OK and plane runs smooth without jumping on it as it does on RW.
How can I fix this?
P.S/ It was installed with accordance to the enclosed manual.
Regards
Philipp
Please uload pictures with you problem. The Airport has flatten, no humpy relief
Please uload pictures with you problem. The Airport has flatten, no humpy relief
Sorry, possibly I explained wrong. It looks proper and flat but when the craft moving by runway its suspensions works full range (from up to down - example like landing in the farm field))) and my virtual camera are being shaked like it move there. On all taxiways aircraft after moving proper as it must be in real ( just a bit shaking).
regards
Philipp
Извините, возможно, я объяснил неправильно. Это выглядит правильно и ровно, но когда корабль движется по взлетно-посадочной полосе, его подвесы работают на полную мощность (от верха до низа - например, посадка на поле фермы))), и моя виртуальная камера дрожит, как будто она движется там. На всех рулежных дорожках самолёты после правильного движения должны быть такими, как должны быть в режиме реального времени (чуть-чуть дрожа).
С уважением
Philipp
Ниже найдите ссылку на видео моего экрана
Hi ,
can`t help. This is not coming from my Airport. Please configure the PMDG correct for departure and disable all other third party tools. Use for test a standard Aircraft
The Runway in LCPH is flat. Never seen that before. No solution from me.
